CCNA 3 Scaling Networks v5.0 Practice Final Exam Answers

CCNA 3 v5 SN Practice Final Exam Answers 2014 Scaling Networks (Version 5.0) 2 Refer to the exhibit. What are two consequences of issuing the displayed commands? (Choose two.) The routing update information is protected against being falsified.* The key is encrypted with the MD5 hashing algorithm. * The routing table of R2 will be secured. OSPF […]

CCNA 3 Scaling Networks v5.0 Pretest Exam Answers

CCNA 3 v5 SN Pretest Exam Answers 2014 Scaling Networks (Version 5.0) – ScaN Pretest Exam 1 What is a disadvantage of NAT? There is no end-to-end addressing. * The router does not need to alter the checksum of the IPv4 packets. The internal hosts have to use a single public IPv4 address for external […]

CCNA 3 R&S: Scaling Networks Final Exam Answers

 CCNA 3 R&S: Scaling Networks Final Exam Answers 2014 1 Refer to the exhibit. A network administrator is attempting to upgrade the IOS system image on a Cisco 2901 router. After the new image has been downloaded and copied to the TFTP server, what command should be issued on the router before the IOS system […]

CCNA 3 Chapter 9 v5.0 Exam Answers 2014

CCNA 3 Scaling Networks Chapter 9 v5.0 Exam Answers 2014   1 Beginning with the Cisco IOS Software Release 15.0, which license is a prerequisite for installing additional technology pack licenses? UC IPBase* SEC DATA 2 When a router is powered on, where will the router first search for a valid IOS image to load […]

CCNA 3 Chapter 8 v5.0 Exam Answers 2014

CCNA 3 Scaling Networks Chapter 8 v5.0 Exam Answers 2014   1 Which command can be issued on a router to verify that automatic summarization is enabled? show ip eigrp neighbors show ip protocols* show ip interface brief show ip eigrp interfaces 2 Which address best summarizes the IPv6 addresses 2001:DB8:ACAD::/48, 2001:DB8:9001::/48, and 2001:DB8:8752::/49? 2001:DB8:8000::/48 […]

CCNA 3 Chapter 7 v5.0 Exam Answers 2014

CCNA 3 Scaling Networks Chapter 7 v5.0 Exam Answers 2014   1 Place the options in the following order: first – not scored – third second 2 Refer to the exhibit. Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface? network 172.16.23.64 […]

CCNA 3 Chapter 6 v5.0 Exam Answers 2014

CCNA 3 Scaling Networks Chapter 6 v5.0 Exam Answers 2014   1 The network administrator has been asked to summarize the routes for a new OSPF area. The networks to be summarized are 172.16.8.0, 172.16.10.0, and 172.16.12.0 with subnet masks of 255.255.255.0 for each network. Which command should the administrator use to forward the summary […]