Tag Archives: TFTP NVRAM

CCNA 2 R&S Essentials Practice Final v5.0 2014 exam answers

By | 29 noviembre, 2013

CCNA 2 R&S Essentials Practice Final v5.0 2014 exam answers   1 Which command would be best to use on an unused switch port if a company adheres to the best practices as recommended by Cisco? switchport port-security mac-address sticky ip dhcp snooping switchport port-security mac-address sticky mac-address switchport port-security violation shutdown shutdown* 2 Refer to the exhibit. An… Read More »

CCNA 2 Chapter 5 v5.0 Exam Answers 2014

By | 19 noviembre, 2013

CCNA 2 Chapter 5 v5.0 Exam Answers 2014 1 Fill in the blank. Do not use abbreviations. A network engineer is troubleshooting the configuration of new VLANs on a network. ​Which command is used to display the list of VLANs that exists on the switch? ” show vlan ” 2 What is a disadvantage of using multilayer switches… Read More »

CCNA 2 Chapter 4 v5.0 Exam Answers 2014

By | 19 noviembre, 2013

CCNA 2 Chapter 4 v5.0 Exam Answers 2014 1 What type of IPv6 address is required as a minimum on IPv6 enabled interfaces? static global unicast link-local* loopback unique local 2 In order for packets to be sent to a remote destination, what three pieces of information must be configured on a host? (Choose three.) default gateway* hostname… Read More »

CCNA 1 Routing and Switching: Introduction to Networks Final Exam

By | 13 noviembre, 2013

CCNA 1 v5.0 R&S ITN Final Exam 2014 1 Refer to the exhibit. The network administrator enters these commands into the R1 router: R1# copy running-config tftp Address or name of remote host [ ]? When the router prompts for an address or remote host name, what IP address should the administrator enter at the prompt? 192.168.9.254 192.168.10.1 192.168.10.2… Read More »

CCNA 1 v5 Introduction to Networks Pretest Exam Answers 2014

By | 12 noviembre, 2013

CCNA 1 v5 Introduction to Networks Pretest Exam Answers 2014 1 2 The failure rate in a certain brand of network interface card has been determined to be 15%. How many cards could be expected to fail in a company that has 80 of the cards installed? 10 12* 15 8 3 If a technician uses an average… Read More »

CCNA 1 v5 Introduction to Networks Chapter 10 Exam Answers 2014

By | 11 noviembre, 2013

CCNA 1 v5 Introduction to Networks Chapter 10 Exam Answers 2014 1 Which three layers of the OSI model provide similar network services to those provided by the application layer of the TCP/IP model? (Choose three.) physical layer session layer* transport layer application layer* presentation layer* data link layer 2 Which two tasks are functions of the presentation layer?… Read More »

CCNA 1 v5 Introduction to Networks Chapter 9 Exam Answers 2014

By | 11 noviembre, 2013

CCNA 1 v5 Introduction to Networks Chapter 9 Exam Answers 2014 1 Refer to the exhibit.   How many broadcast domains are there? 1 2 3 4* 2 How many usable host addresses are there in the subnet 192.168.1.32/27? 32 30* 64 16 62 3 How many host addresses are available on the network 172.16.128.0 with a subnet mask… Read More »

CCNA 1 v5 Introduction to Networks Chapter 8 Exam Answers 2014

By | 11 noviembre, 2013

CCNA 1 v5 Introduction to Networks Chapter 8 Exam Answers 2014 1 Fill in the blank. The decimal equivalent of the binary number 10010101 is    “149” . 2 Place the options in the following order: [+] 192.168.100.161/25 [+] 203.0.113.100/24 [+] 10.0.50.10/30 [#] 192.168.1.80/29 [#] 172.110.12.64/28 [#] 10.10.10.128/25 [*] 10.0.0.159/27 [*] 192.168.1.191/26 [+] Order does not matter within this… Read More »

CCNA 1 v5 Introduction to Networks Chapter 7 Exam Answers 2014

By | 11 noviembre, 2013

CCNA 1 v5 Introduction to Networks Chapter 7 Exam Answers 2014 1 A PC is downloading a large file from a server. The TCP window is 1000 bytes. The server is sending the file using 100-byte segments. How many segments will the server send before it requires an acknowledgment from the PC? 1 segment 10 segments* 100 segments 1000… Read More »